Tagged with 'testing'

The 8-step process engineers use to test grease interceptors

TZ-1826 testing video screenshotThe American Society of Mechanical Engineers (ASME) developed standards in the 1990s to govern passive hydromechanical grease interceptors. The standard was developed in collaboration with the Plumbing & Drainage Institute, and is referenced by the Uniform Plumbing Code, the International Plumbing Code and the National Standard Plumbing Code.

The standard — ASME A112.14.3 — is the measure by which passive grease interceptors (including many of Thermaco’s products) are measured. If it meets the standard, then the interceptor can be used in many installations. If it doesn’t, then it’s a non-starter. 

So how, exactly, does one test a grease interceptor to see if it meets the ASME standard? 

Read more

Look what happened when we combined 19,200 gallons of water and 1,920 pounds of lard

Trapzilla TZ-1826 Grease InterceptorA commercial kitchen wouldn’t repeatedly send 200 gallons of burning water and 20 pounds of hot lard through its grease interceptor even on the busiest night. And a blizzard would make it even less likely. 

But this past February, that’s what we subjected our newest grease interceptor, the Trapzilla TZ-1826, to — during a storm.

The TZ-1826 is the third-generation Trapzilla, with a tank design optimized to retain more grease in as small a footprint as possible. We tested the TZ-1826 to the ASME standard to determine its efficiency and capacity.

We didn’t expect what happened next.

Read more